Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Filter by:
Sort by:
Looking to turn my separate toilet and bathroom into one room there is tiling the one side of the wall along with a radiator. Wanted to know the cost of removing the wall and what the cost would be to redo the bathroom also, room would be small to medium size ,thanks.
I have a hardboard floor in my kitchen and living room which have cork tiles fitted to them. I’m told they were glued down. Is there any specific method to lift off these tiles and remove them? We don’t want to leave the layers beneath damaged or with any major glue residue of we can help it.
I'd like a cost per square metre rate for the installation of OSB board subfloor and also skirting for a job in London. The floor area is 50m2.
Should I go with a flat and lower sheen paint if I want to paint my living room? What might it depend on?
Am preparing to tile my house with a sand, Cement and Lime mortar! Is that safe?
Hello We have had a combi installed which has replaced our old conventional boiler. We have however had lots of problems with the new boiler. There are strange noises coming from the boiler & also problems with the water pressure. If I put taps on it causes the bath hot tap to come on. The stream of water coming out of the kitchen hot tap was so fierce we could not turn the tap off so are no longer using the hot tap in the kitcen. The engineer insists it is just because we have old taps and is going to replace the taps. The main issue is that he did the boiler installation in a day with a colleague. I am worried about whether they took any shortcuts but don't know enough about this. Please advise as to whether you think this is just to do with the taps or whether it could be a problem with the boiler installation. Everything worked OK with the old boiler.
Why do the pipes make a noise when the washing machine is filling
How much cost and time is required to remove kitchen worktop? The hob and sink will be reattached to a new worktop which the provider will be fitting, but they won’t remove it. Need someone that can disconnect and reconnect gas supply
Do you need to buy all the materials/supplies as part of a package or from the same provider for installing a stud wall or can you mix and match from different suppliers and still have it work okay? Can I buy these from different places and how di I know that they’re compatible? I’m just looking for ways to save on money for this project as best I can without compromising the safety and success of the installation. Thank you.
Should I have smart heating controls fitted? Can they be added to an existing heating system?
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year