Ask a Trade: Bathroom Specialists

I need a new bathroom ceiling. The flat upstairs had a leak and my ceiling now needs replaced. Can someone tell me what kind of tradesman I need for this job? Thanks

I have two sets of taps in my bathroom (sink & bathtub) and would like to replace both of them with new mixer taps – for easier use and due to the taps’ age and wearing. I would to prefer to install these myself if possible, as I’ve had some experience with tap installation in the past. Are there any major changes that I will need to take into account beyond the piping of the hot and cold water to the single tap? Anyone with any experiences of installing mixer taps would be appreciated.

Hello, I will be doing some tiling work in my bathroom to replace some damaged tiles. I’ve not done any tiling work in a bathroom before – so I don’t know if there is any special sealants or other products I should be using. At the moment I am planning to use some bathroom specific tile adhesive and some tile grouting to seal the gaps between the tiles after they have been fitted. Is grouting absolutely necessary if the tiles are already fitted due to the adhesive already? Will I need any other products for fitting tiles? If there is any other tools or products anyone would recommend using to get the job done right, please let me know.

I have tiles under tiles on the bathroom wall around the bath. Will there be a problem taking them off?

Hi, I am looking for good advice regarding installing a wetroom to a ground floor flat with concrete floors. Can this be done?

Hi all I have found my bathroom sink’s tap for cold water suddenly has very low pressure, yet the hot water tap in the sink runs fine. The baths’ taps are also running fine. Also, there is a mixer tap and I have a combi boiler setup. Does anyone have any idea how this has happened or how I can fix it? Or will I need to ring a plumber?

I have has my bathroom’s shower fully-tiled recently. Does this need any grout sealant applied to it? If so: Is there any specific type I should use? Will it affect the look of the tiles?