Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Filter by:
Sort by:
Hi, How much (approximately) would it cost to install an RSJ to an external load bearing wall between a dining room and extension in order to open the dining room into the kitchen? This is to make an L shaped kitchen diner. This job would involve the removal of a wall below the RSJ, approximately 7ft x 6ft.
How to mix mortar? Is this something that a DIY enthusiast should do and can I do it safely?
Old oven is a plug in, but the new one which we like has to be wired How much roughly would it cost to install the correct circuit
I had a smart meter fitted and now my shower only has hot water for 10 mins. Can this be related to my fusebox?
I had new windows fitted 5 years ago without trickle vents. Can I get these fitted retrospectively? Will it solve a minor condensation problem?
How much would it cost to secure my TV aerial? needs to be done asap
Hello. I have a boiler flue that runs through the kitchen wall, into the adjacent room and out through the external wall in that room. I intended to use this room as a bedroom for my little girl. Is it possible ie safe to box a flue pipe in in this sort of situation? Thanks!
I have power (using a mains tester screwdriver ) going to the fan switch in air cupboard. Power showing going to the new fan. It has a humidifier sensor. I ran the shower but nothing? And ideas. It’s a new fan as the other one never worked when I moved in.
How much would it cost to fit 6 internal doors with fittings?
I am building a lean-to car port and have installed the 3 uprights in 100mm x 100mm x 3m in oak. I was planning to build the roof structure in softwood using 75mm x 50mm with a 5m long cross member on the top of the oak uprights. Due to an ordering error I have 2 extra 100mm x 100mm x 3m oak pieces. How could I connect these on the top of the uprights, I was planning to use 150mm timber lock through the soft wood cross member but if using the oak would have to abut the 2 ends of the oak beams on top of the centre upright. Is there a special bracket/connector for the centre column? Thanks in advance for your comments. Andrew
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year