Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Filter by:
Sort by:
NEED IDEA OF COST OF INSTALLING SANIFLO TOILET IN UPSTAIRS ROOM
What’s the best spot in a garden to have a shed constructed?
When it rains water drips down my chimney. I think there is a plastic cap on top that’s supposed to keep rain out as the chimney is not used. I thought rain was going sideways through the slats on the chimney pot but it happens when the rain is going straight down so I think it might need looking at but who do I call?
Hi, I'm just wondering what is the best brand or store to go with to buy a marking gauge from?
I have has my bathroom’s shower fully-tiled recently. Does this need any grout sealant applied to it? If so: Is there any specific type I should use? Will it affect the look of the tiles?
Hi, I’m confused because when I hang lining paper I can achieve a good finish, I very rarely see any joint and I can’t figure out why if I hang lining paper on graphite thermal wall lining which has a kind of paper on it, I have joint problems! When I paper over it I seal the paper on wall lining, then hang lining paper and it looks the same as it would on just plaster. It’s when I emulsion that I can’t understand because it shows every joint not as a gap but it’s as if the paint builds up on joints. I was thinking paint may be lifting joins but then none appear lifted when looking closely. Also, why would they lift if stuck with the same ready-mixed adhesive used for plastered walls and recommended for the thermal lining? Like I say there is no appearance of joint not stuck, just looks like a build-up of paint on the joint?
Do most heating engineers perform a power flush per standard when installing new boilers, etc.?
What level of voltage is dangerous and even deadly and what voltage levels are more harmless?
I have a rocking horse that I have stripped of old Scrim and plaster. If I replace the scrim, what type of plaster do I need to re-coat it.
Ours has just stopped mid-cycle and won’t drain. Do I need an appliance repair person or can any plumber sort this?
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year