MyJobQuote Logomyjobquote
  • Post a Job
  • Trade Signup
  • Ask a Trade
  • Cost Guides
  • About
  • Login
  • Ask a Tradesperson

    Got a question that only a tradesperson can answer?

    Post your Question

    Search our questions

    I have has my bathroom’s shower fully-tiled recently. Does this need any grout sealant applied to it? If so: Is there any specific type I should use? Will it affect the look of the tiles?

    Asked by LAURA on 26th Feb 2019

    I have some kitchen cupboard doors which are starting to look a bit worse for wear. It’s had some basic water damage which have turned created a few dark patches (from some leaks of the sink above). Should I replace these doors or are they possible to clean up, repair & repaint? If I can repaint them, what types of paint are best to use? Thanks

    Asked by Claire Kate on 25th Feb 2019

    Hi all I am working on building my own brick barbecue at the moment. I have a completed base of concrete and now trying to sort a good mortar mix. I’ve been told to use a ratio of 6:2:1 of sand:lime:cement, but does not seem to have turned out as I had hoped which dries exceptionally quickly and does not bind with the bricks to stick together. Has anyone any advice or suggestions? Should I try a different ratio for the mix?

    Asked by khalid on 25th Feb 2019

    Ask a Trade

    Got a question that only a tradesperson can answer? We have thousands of trades ready to answer any question you may have.

    Ask your Question

    Hello I have been trying to get my TV to connect to an aerial point of the home, but there apparently no TV signal. This is an aerial port I have not used before and features two cables from the point. The aerial seems to have worked fine through other ports in the past. Has anyone any advice on this issue?

    Asked by Christian on 25th Feb 2019

    Hello, I have installed a new bath shower screen recently. It does fit, but seems to be a little looser than expected. Does this happen usually, or ought there be more stiffness or friction to limit it’s movement? Also – I have a seal leak at the end of the hinge. Is there a possible way to stop this? Or any recommended seals I should use instead? Any advice would be appreciated – thanks!

    Asked by asa on 25th Feb 2019

    Ready to get a price for your home improvement project?

    get started