Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}

Filter by:
Sort by:
NEED IDEA OF COST OF INSTALLING SANIFLO TOILET IN UPSTAIRS ROOM
How do you insulate a wooden shed? What is the best material?
Do you need to wet the wall before you start plastering?
What’s the best spot in a garden to have a shed constructed?
When it rains water drips down my chimney. I think there is a plastic cap on top that’s supposed to keep rain out as the chimney is not used. I thought rain was going sideways through the slats on the chimney pot but it happens when the rain is going straight down so I think it might need looking at but who do I call?
Hi, I'm just wondering what is the best brand or store to go with to buy a marking gauge from?
I have has my bathroom’s shower fully-tiled recently. Does this need any grout sealant applied to it? If so: Is there any specific type I should use? Will it affect the look of the tiles?
Hi, I’m confused because when I hang lining paper I can achieve a good finish, I very rarely see any joint and I can’t figure out why if I hang lining paper on graphite thermal wall lining which has a kind of paper on it, I have joint problems! When I paper over it I seal the paper on wall lining, then hang lining paper and it looks the same as it would on just plaster. It’s when I emulsion that I can’t understand because it shows every joint not as a gap but it’s as if the paint builds up on joints. I was thinking paint may be lifting joins but then none appear lifted when looking closely. Also, why would they lift if stuck with the same ready-mixed adhesive used for plastered walls and recommended for the thermal lining? Like I say there is no appearance of joint not stuck, just looks like a build-up of paint on the joint?
Do most heating engineers perform a power flush per standard when installing new boilers, etc.?
There’s a electric radiator in our downstairs toilet that we’ve never used and we want to remove. Can we remove this ourselves, put the wires behind the wall and just plaster over the holes In the wall?
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year