Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Filter by:
Sort by:
Hi, im looking to have my polycarbonate roof covers in a uv film, or painted in special paint. I'm called so many companies and can't find one that will do this.... can anyone help?
I have a fourteen-year-old Worcester boiler that is leaking a bit. This has been diagnosed as a fault with the heat exchanger. The boiler is still working. So, is it better to repair with a new heat exchanger or replace the boiler? Can someone give a rough estimate of the relative cost differential?
Why does the pull cord in the bathroom not switch the light on? Normally it would click and the light will be on, now it still clicks but the light won't be on. other lights come on in the house. Do i need to replace the switch?
I have some kitchen cupboard doors which are starting to look a bit worse for wear. It’s had some basic water damage which have turned created a few dark patches (from some leaks of the sink above). Should I replace these doors or are they possible to clean up, repair & repaint? If I can repaint them, what types of paint are best to use? Thanks
Hi all I am working on building my own brick barbecue at the moment. I have a completed base of concrete and now trying to sort a good mortar mix. I’ve been told to use a ratio of 6:2:1 of sand:lime:cement, but does not seem to have turned out as I had hoped which dries exceptionally quickly and does not bind with the bricks to stick together. Has anyone any advice or suggestions? Should I try a different ratio for the mix?
Hello I have stone walls for my house which have been damaged and eroded over time that may need refiling, with some small patches of decolourisation in some areas from erosion/damage over time. These are Bath stone walls specifically and, where possible, I would like to resolve this myself. Are there any suitable materials that I can use without damaging the stonework?
My RCD keeps tripping and I can't find anything obvious that's doing it. Most of the appliances have been unplugged and I still can't figure it out. The entire system trips and not just a single fuse. Does anyone have any advice on how to find the fault?
Hello all I am in the process of kitchen renovations at the moment and will need a new gas hob to be installed. I had thought his would be a task only a Gas Safe registered engineer would be able to do legally, however the builder involved in my renovation work tells me that it is a simple change of disconnecting the old hob and reconnecting to the new, so it would be too minor to need a specialist and that he could do it himself. Is this the case, or am I having the wool pulled over my eyes? I’d like to hear from the horse’s mouth on this, from actual engineers.
Hello All, I want to have garage consumer unit but not sure where to start. Does any one have any advice as to what I should be looking for?
with skirting and architrave removed, would you expect a plasterer to skim close to the floor on a full room plaster skim?
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year