Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Filter by:
Sort by:
If the heat exchanger of my boiler has broken down, should I just replace my boiler entirely?
Hello! I'm replacing my 4 plate Hotpoint gas cooker (60cm; Electrical Load = 4.93kW) with a 6 plate Duel Fuel ILVE range cooker (100cm, Electrical Load = 5.1(kW). Can I use the same cooker socket I'm currently using, or do I need a higher voltage socket? Also, is this possible to self-instal, or does it need an electrician? Thanks, Christine
Why might stumps or joists have worn and eroded over time? What can I do about this?
my water supply is hot when the tap is opened but after a short time the water runs cold it is
How much do plumbers charge for labor to unclogg a toilet blockege
Hello and thank you in advance for answering my question. In my kitchen the boiler pipe work is covered by an L shaped wooden boxing which is tiled with the same tiles as those on the kitchen walls. I assume the tiler who completed the kitchen tiling created this under the previous owners of my flat. A couple of the tiles from the corner section have fallen off. I'd like to reattach them but I am not sure what the correct adhesive to use is. From some initial research I have done I have seen a range of adhesives either ready made or not that come in a range of sizes but it seems many may not be good for sticking tiles to wood. I am confused about what is suitable to buy. Also there is a tile trim that has come away as well as the tiles. When reattaching the tiles do I stick down the trim to the wood first using the adhesive and then add more adhesive to the trim and place the tiles on top? I have never done any type of tiling before. Many thanks
Our plumber has quoted a 6 month guarantee for his workmanship- is this the norm?
Want to replace the flat roof on a double garage (measuring 5m by 5.5m ) with fiberglass material (CURE IT). I will also require the roof boards replace. What will it cost?
How can I reduce the cost of removing a chimney breast?
Hi, Unfortunately someone has managed to snap off the aerial connector on my TV when they were mounting my TV on the wall. I am trying to find someone near who can potentially fit a new one on my TV but I have also read about a 'HDMI adaptor' that I could use to get normal TV channels. Does anyone have any that they would recommend? Trying to figure out the best option. Any advice would be appreciated. Thanks
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year