Filter by:
Sort by:
Which would be the easiest/quickest and most beneficial to use?
Is it better to board or plaster over artex?
A builder repaired a wall affected by a leak. I explained that it needed to be completely dry before replastering, but he applied PVA, plastered and skimmed it anyway. He says the wall was dry, but it still feels noticeably cold, so I’m concerned there may be remaining moisture. The plaster is also uneven and overlaps the skirting board; he says sanding will fix this. Please advise: 1. Should the wall be checked with a damp meter before further work or painting? 2. Could remaining moisture show through the paint? 3. Could applying PVA and plastering too soon trap moisture? 4. If the wall is still damp, should the plaster be removed and the wall allowed to dry before replastering? 5. Will sanding properly correct the uneven finish? I want to resolve the moisture issue properly before decorating\.
What do plasterers charge on a daily basis in Glasgow on average? How about their hourly charge? Are quotes about the same across the city or do different contractors offer very different quotes?
What brands do you think are the best go with for browning plaster?
How much would it cost to skim over artex ceilings in a house built in 1996. Rooms with artex are living room, dining room, kitchen, stairs and landing, 2 bedrooms and a bathroom?
Hi, I'm looking at various types of plaster. Just wondering, what is Thistle plaster and what are its pros and cons?
I have a ceiling in one room which has been progressively falling apart. It’s approximately 1.5 metres square in size. What is the best way for me to repair this growing gap in the ceiling? Will there be a need to remove any additional plasterboard in the process or just this section?
Do I need to remove old wallpaper beforehand, or will the plasterer remove along with blown plaster.
I’ve got swirl patterned ceilings around the house but over the last few months the plaster has started to come off only over the screws that hold the plaster board up (I think its plasterboard underneath?). It has left a few small circular holes dotted around the edges of the ceiling where the screw heads are now visible. Why would this be happening? How can I fix it?
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year